Repository navigation
hw: flat indoor CR2032 box for the full v3.0 board - #90
Merged
Merged
Conversation
enclosing/flat/flat_box.scad: base + lid on 4 M3 x 6, 3 M3 standoffs, wall tabs; height set by C1 (11.5 mm): closed 21.5 mm, base 124.8 x 55.3 (BME280) or 58.8 (DS18B20) with tabs. Sensor selectable: BME280 breakout soldered in J3, or DS18B20 in J5, with vent slots next to it (no chamber: the board sleeps 99 % of the time). 433 MHz module lying flat over U1, antenna in a wall groove. Indoor only (no seal). pcb.scad: pcb_v3(bare = true) leaves out the parts this build does not fit. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Base 114.8 x 45.3 (BME280) / 48.8 (DS18B20) x 19.5 mm without tabs, was 110.8 x 55.3; antenna groove runs around the pillars. Renders and README updated. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
New model
enclosing/flat/flat_box.scad(first implementation, not printed):sensor = "bme280"(breakout soldered in J3, JP6 1-2) or"ds18b20"(TO-92 in J5), vent slots next to it; no separate chamber (the board sleeps 99 % of the time). Indoor only.radio_lift), antenna in a wall groove.pcb_v3(bare = true)inpcb.scadhides parts this build does not fit (default unchanged).enclosing/flat/rendu_ouvert.png,rendu_eclate.png; README; index row inenclosing/README.md.To check on hardware: FS1000A size and pin length for the flat mount, DS18B20 leg bend; no Orca project yet (STL export only).
🤖 Generated with Claude Code